Assignment

Digital Signal Conditioning

Work the problems below. To receive any credit, you must show all work. You may submit your work in a word processing document or in a pdf file. Graphic files are not acceptable submissions. Your file submission document should be entitled Week2AYourGID (replace YourGID with your specific GID).

1. A “1” signal is required to trigger an alarm, if the fluid level in a tank is more than 3m deep. The level sensor gives an output of 9.3mV for every centimeter increase in depth. What is the required alarm voltage?
2. In problem 1, if there are waves with amplitude of 35 cm due to pumping, what is the value of R2 to give a dead band with a 5-cm safety margin to prevent the comparator output from going low? Assume R1= 5k ohms, and output high = 5V.
3. An 8 bit DAC has a reference voltage of 5V. What would be the voltage corresponding to a binary word of 10010011?
4. What is the conversion time for the dual slope converter shown in the figure below if R = 1M ohm, C = 5nF, VR= 5V, integration time of 50 ms, and the input voltage is 8.2V? What is the capacitor discharge time?
5. A temperature between -10 and +250 is converted into a 0- to 5.0 Volt signal. This signal is fed to an 8-bit ADC with a 5 Volt reference. What is the actual measurement range of the system? What is the resolution

Lab

Digital Signal Conditioning Lab

1. For the comparator below, complete the design so that the threshold voltage is 1.25V which means that if the input is below 1.25V, the output will be HIGH and if its greater, it will be low. Once the resistance values are found, use Multisim to validate the design by applying a sine wave of 3Vpp into Vin and plot the results.
2. Using the 8 bit Digital-to-Analog (VDAC) in Multisim, design the part with a 12V reference. Next apply the following inputs in the table below and both calculate and measure the output voltage. What is the resolution of the DAC? Show your circuit and results in Multisim.

Digital Inputs
Calculated Analog Output Voltage
Measured Analog Output Voltage7654321000000001  00001001  00010000  00011111  01010101  10000000  11111111  

Home workIn your opinion, what level of the socioeconomic strata (i.e., social class – lower, middle, or upper) in the United States is most affected by cybercrime? Why do you believe that stratum is more affected than the others? Explain and thoroughly support your answer.Which of the emerging trends cited by experts in the article “Security Predictions 2013-2014: Emerging Trends in IT and Security” (found at http://www.sans.edu/research/security-laboratory/article/2140) do you think has had (or more properly, will have) the most significant impact on information security, from a cybercrime perspective? Why?